OMNICOM® for Windows® is a real-time PC configuration program for use with OMNI flow computers.
Designed around the OMNI operating system, it emulates the keypad data entries required to configure OMNI 3000 and OMNI 6000 flow computers and controllers.
Full-color pull-down menus and entry-sensitive help screens guide you quickly through an I/O configuration. Configuration can also be prepared offline and uploaded as needed.
*OMNICOM® for Windows® v1.54 (February 2013) is compatible for use with Revision xx.74 or higher EPROMs installed in the flow computer. Do not use with older versions of firmware as this may cause the contents of RAM in the flow computer to become corrupted. If an OMNI's SE module is upgraded with v1.57 or 1.57.60, it is highly recommended that you install, at a minimum, OMNICOM v1.48 to support the additional fields.